72
MAINTENANCE
It is envisaged the maintenance of the VIARIS chargers should be very low,
limited to:
Cleaning Tasks.
Operation and voltage input voltage checks.
Recommended annual service.
For cleaning and checking equipment connections charger MUST be
disconnected from power supply.
For the external cleaning of the equipment, it is recommended to use
a soft, dry cloth, e.g. a microfiber cloth. Do not use abrasive materials
or detergents.
TECHNICAL CHARACTERISTICS
Feeding |
Nominal frequency | Depending on characteristics label.
Power |
self-consumption Single-phase Tree-phase
Vacuum 4 W 4 W
Load function 7 W 14 W
Charging modes (depending on model) Modes 1 and 2 according to EN 61851-
1 (Schuko)
Mode 3 according to EN 61851-1
Connector cable Type 2. Load mode 3: according to EN
62196-2
Communication Wi-Fi 802.11 b/g/n
Closing of the envelope with screws
Protection class Case II. Insulating envelope
Degree of protection IP55 according to EN 60529
Degree of mechanical protection IK10 according to EN 62262
DRC-DD 6 mA protection.
Activation/Stop modes Touch or RFID configurable by App
Type of terminals Terminals with screw
Peeling length 12 mm
Operating temperature -30 °C to + 50 °C
To Next Page
Loading...
