CAUTION
It is very dangerous to work in slopes.
Never work in slopes more than 15°(RM882/952) and 20°(RM982F).
WARNING
Check that there is nobody in the mowing area and
especially in the thrown object zone (Figure 10).
Stop the machine immediatly when hitting something. Let
the machine cold and clean. Check the machine or ask
your dealer to check if the machine is not damaged.
HOW TO STOP THE MACHINE
⚫ Pull cutting blade lever to the top in disengage position,
pull cutting height control lever to the top on travel
position.
⚫ Hold on the lever in neutral position « N ».
⚫ Turn off ignition key to stop position, and remove it.
⚫ Engage and lock the parking brake, and close fuel cock.
HOW TO CARRY THE MACHINE
⚫ Use a trailer or a truck which is able to carry the
machine. When loading the machine, use bridge which
is able to resist to 500 kg, 30 cm wide and equipped
with unslipping surface. Check that the slope should not
be more than 16°. The maximam is 16° (Figure 11).
LOADING :
⚫ Check that cutting blade is disengage and in travel position. Engage the differantial lock.
⚫ Put the bridge from truck to ground and lock it exactly.
⚫ When the machine is loaded, engine rpm is maximam, and load it slowly and carefully.
⚫ After the machine is loaded, Turn off ignition key to stop position, and remove it. Engage and lock
the parking brake, and close fuel cock. Fix the machine to the truck with roap
STORING THE MACHINE
⚫ Clean the machine perfectly. Touch up paint to prevent rusting.
⚫ Check the worn and damaged parts, replace new parts as required
⚫ Do the normal maintenance refer accrding to the maintenance chart.
⚫ The machine should be stored in a dry and protected area
⚫ Remove ignition key.
To Next Page
Loading...
