OREC RM881 - © SAT 2021-05-06
• Check that the machine can work properly before any use.
• Check that all the shields, grids and safety guards are in place
and in a good condition.
• It is strictly forbidden to carry persons or animals onto the
machine during the work or during the transportation.
• Check that nobody stands behind the machine before moving
back.
Never stop or start roughly when working on a slope. Never
use the machine to work on a
stepping terrain.
Reduce the speed when running on
a slope. And turning straight to
prevent from any risk of losing control.
Be very careful when bordering ditches.
Stop the engine, apply the parking brake and remove the ignition key
before any intervention on the machine.
Never work under the machine or its parts when lifted, unless they are
blocked and maintained into position with sufficient security.
When running on a slope, working direction is going up or down but never across the slope.
Avoid unsteady embankments, holes or rocks. They might be caused injury during operation.
Be careful when working on slopes.
Keep away from high-tension lines and obstacles. A contact with
a high-tension line cause electrocution and death.
Stop the machine progressively when lifting or lowering the
machine.
When the machine is stoped mowing, stop the engine and
engage the parking brake before leaving the machine.
Check the all safety switches is engaged.
• Move the machine only when correctly sat down in the
operator’s seat
Visually check hydraulic leaks and if some parts are faulty or missing. Repair before use.
A hydraulic oil jet due to a leak can penetrate under the skin causing serious injuries. In this case
you must immediately consult a doctor.
• Never change the adjusment of the safety valve, it is set in the
factory. Unsetting this valve would cause failures.
Ensure that the user of
the machine has already
read and understood this
manual and that he is
aware of all the safety
instructions before any use.
Always use a chuck and bronze hammer when replacing or
repairing on the pins and bolts at the end of rams, rod … etc
in order to avoid the projection of metal fragments.
To Next Page
Loading...
