7. 点検表
- 24 -
③ Depress the parking brake pedal and apply the brake
stopper. If the change pedal or shift lever is not in the
neutral “N” position, return it to the neutral “N” position.
④ Set the knife clutch lever to the "off" position and the
cutting height adjustment lever to the "move" position.
Reference︔
The Blade clutch lever is linked to the cutting height adjustment lever. Move the cutting
height adjustment lever to the "move" position and the Blade clutch lever will also return to
the "off" position.
⑤ After confirming that the shift lever is in the neutral “N”
position, pull the Choke lever.（The state where the lever
is pulled is the "closed" position, and the state where the
lever is pushed is the "open" position.）(This is not
necessary if the engine is warmed-up.)
⑥ Move the Throttle lever to the middle position
between High speed and Low speed。
Blade clutch lever.
Cutting height adjustment lever
Choke lever
Throttle lever
closed
Brake stopper
Parking brake pedal
Change pedal
To Next Page
Loading...
