OREC SH61 - Safety Rules

OREC SH61 et SH71 - © SAT 02/06
5
SAFETY RULES
CAUTION
Some of the illustrations show the machine with no guard, no shield. Never use the machine
without these devices.
• Learn to stop the machine in case emergency.
• Read this manual.
• Do not let anybody use the machine before having read and understood
this manual.
• Do not let children use the machine.
• Do not wear loose clothes. They might be grasped by moving parts.
• Always wear protection equipments for when using the machine.
• Only work during daylight or with a good artificial light.
• Check that the safety instruction stickers are in place and in a good condition.
• Keep the machine free from debris or mud.
• Check that the machine can work properly before any use.
• Check that all the shields, grids and safety guards are in place and in a good state.
• It is strictly forbidden to carry persons or animals onto the machine during the work or during the
transportation.
•
Never stop or start roughly when working on a slope. Never use the machine to work on a stepping
terrain.
•
Reduce the ground speed when running on a slope and when turning
straight in order to prevent from any risk of losing control.
•
Be very careful when bordering ditches.
•
Stop the engine, and remove the sparking plug ignition cover before any
intervention on the machine.
•
Never work under the machine or its parts when lifted, unless they are
blocked and maintained into position with sufficient security.
•
When running on a slope, always work going up or down but never
across the slope.
•
Steer clear of unsteady embankments, holes or rocks. They might be dangerous during manœuvres
or transport.
•
Keep away from electric wires and obstacles. A contact with electric wires cause electrocution and
death.
•
Stop the machine progressively when lifting or lowering the machine.
•
When stopping the work, stop the engine and remove the sparking plug ignition cover before leaving
the mower.
•
Engage all the safety equipments.
Move the controls only when correctly sat down in the mower
•
Visually check hydraulic leaks and if some parts are faulty or missing.
Repair before use.
Never change the adjusment of the regulator, it is set in the factory.
Unsetting this valve would cause failures.
•
Ensure that the user of the machine has already read and understood this
manual and that he is aware of all the safety instructions before any use.
•
Always use a chuck and bronze hammer when replacing or intervening on the pins and bolts at the
end of rams, rod … etc in order to avoid the projection of metal fragments.