EasyManua.ls Logo

OREC SH61 - Operation

OREC SH61
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OREC SH61 et SH71 - © SAT 02/06
10
OPERATION
CAUTION
Check the tightening of bolts, refering to the tightening torque charts
The safety was one of our main worry when designing and manufacturing this machine.
Therefore, negligence in the use of the machine should reduce our efforts to nothing. The
prevention strictly depends on the care and on the skill of the user when applying and
maintening the machine.The best safety method remains a careful and skilled user ; we wish
you to be this kind of user.
The user of this machine is responsible for its safe use. He must be a skilled user specially trained for
the use of this machine. Read the safety instructions. This machine has been designed to mow grass.
It is not designed for any other operation. It is no designed to transport other tools or materials that
might damage it and cause injuries to the user. It must not be used to carry persons.
DANGER
Never use the machine without having priory carried out all the maintenance operations as
described in the daily maintenance chapter.
CAUTION
Never let children or unskilled persons use the machine. Check that no bystanders are near
the machine when at work. They could be hit by the moving parts. Nobody must stand on the
machine except the driver. Never put your hands on moving parts.
Starting of the engine
Turn the fuel cock "ON".
Check than cutting blade is disengaged, and travel lever in neutral position « N ».
Set the choke lever if engine is cold or push throttle lever half if engine is hot. Press the brake lever
and pull the starter rope. When the engine has started, push back the choke lever.
Mowing
Adjust the height of cut control bar as needed.
WARNING
Do not forget that it is better to mow a few
grass often than many grass in one operation.
Remember that short grass deteriorate
rapidly in hot and dry weather.
When the cutting height is low , the blade may
hit the ground and it cause demage to the
blade. The thrown objects can injure the
operator, the bystanders, or cause damage to
their properties..
Working in slopes is very dangerous. Never
work in slopes more than 15
°
.
Figure 7
1
2
3

Related product manuals