Oregon Scientific FT101 - Using the Memory; Recalling the Memory; Resetting the Memory

GB
USING THE MEMORY
This product is designed with an internal memory that automatically
stores the date, time, and temperature for the last 10 measurements
taken. The most recent reading is stored as the first record, with all
subsequent records stored as 2 – 10.
Recalling the memory
To recall the memory, press to turn on the
thermometer, then press MEM. The record
number will show in the top left corner of the
LCD display, and the date and time for that
record will alternately flash in the top right corner,
as shown in Figure 4. In the example shown
here, the most recent temperature reading of 99.1 °F was taken on
13 January.
Press the MEM button again to scroll through the records. Press
and hold MEM for two seconds to automatically scroll through all
the records.
Resetting the memory
To erase, or reset, all records stored in the memory:
1. Press to turn on the thermometer.
2. Press MEM to display the memory.
3. Simultaneously press and hold the MEM and mode buttons for
approximately 2 seconds to erase all the records.
11