15
EN
Using your telephone with a PABX or local telephone network
You can use your ThermoDECT telephone with a PABX (Private Automatic Branch Exchange) or
local telephone network. Use of your telephone with a modern system does not require special
adjustment; however, with certain older systems, you may need to insert a pause between the
prefix and the rest of the number.
To set up a prefix:
1. Press the
button.
2. Press to select Setup from the options.
3. Press
.
4. Press
to select PABX setup from the options.
5. Press
.
6. Press
again to select Code 1 from the options.
7. Enter the security PIN for the base, followed by the prefix. For more information about the security
PIN, refer to the next section.
Example: The security PIN for John’s ThermoDECT telephone is “0000”. To dial an external
number in his PABX, he must dial “9”, and then the number. John would enter “0000” and “9” for
this step.
8. Press
to confirm your entry.
9. (Optional) Repeat Steps 6 - 8 to set up a second prefix.
Tip: To return to standby mode, press and hold the
button.
To select a pause duration:
1. Follow Steps 1 – 5 above to enter the PABX setup menu.
2. Press the
button to select Pause setup from the options.
3. Press
to confirm your entry.
Tip: To return to standby mode, press and hold the
button.
Changing the security PIN
Your ThermoDECT telephone is shipped with the security PIN (Personal Identification Number) set to
“0000”. You can change this to any 1-8 digit PIN you choose.The security PIN is used for resetting the
system and identifying the telephone in a PABX (Private Automatic Branch Exchange) or local
telephone network.
To change the security PIN:
1. Press the
button.
2. Press
to select Setup from the options.
3. Press
.
4. Press
to select PIN code from the options.
5. Press
.
6. Enter the new PIN number. The PIN number will not show on the display for security reasons.
7. Press
to confirm the change.
Tip: To return to standby mode, press and hold the
button.
To Next Page
Loading...