Oricom OBH930 - Device Pairing and Registration

13
Getting Started
English
2.4 Registration (Pairing)
The Baby Unit is pre-registered to your Parent Unit. You do not need to
register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the
procedures below:
1. Press the button and the menu bar will pop up.
2. Press the
<
LEFT button or
>
RIGHT button until is highlighted, and
the - (delete) / + (add) / (view) / (scan) menu will pop up.
3. Press the
+
UP button or
-
DOWN button to select + (add), and press
the button to conrm.
4. Camera 1 / 2 / 3 / 4 will pop up. Press the
+
UP button or
-
DOWN
button to select the desired Camera, and press the button to start
searching for a camera unit.
Note: If a camera is currently paired with the Parent Unit, its camera
location (with a * beside it) cannot be selected for a new registration.
5. Press and hold the PAIR button on the bottom of the Baby Unit until
the Parent Unit nds the camera, beeps and PAIR OK appears on the
screen. The video from the camera will then appear.
Note:
A camera can only be registered to one Parent Unit at any one time.