Two Channel Bridged Configuration
● Front and rear channels are configured for bridged two-channel operation.
● Lowest recommended impedance for both front and rear channels is 4W.
● Crossover and gain configurations are independently adjustable between the
front and rear channels.
● Two-channel operation is recommended for this operational mode.
● Front and rear outputs can be configured for high-pass, low-pass, or full range
operation.
● Front and rear outputs can be configured for stereo (right channels will have right
output, left channels will have left output) or summed two-channel operation
(front speaker bridged, rear speaker bridged).
● Only the rear speaker is controlled when using the RGC-1.
Three Channel Stereo/Bridged Configuration
● Front channels are configured for two-channel stereo operation.
● Front channel lowest recommended impedance is 2W stereo.
● Rear channels are configured for a single channel bridged output.
● Rear channel lowest recommended impedance is 4W.
● Crossover mode, output and gain configurations are independently adjustable
between the front and rear channels.
9
©2004 Directed Electronics, Inc.
To Next Page
Loading...
