13
MANUAL TV STATION PRESETTING
1
2
4
Press (rising frequency) or (falling frequency)
once. The search starts. It stops at each broadcast
5
Press ▲ or ▼ to select the
PRESELECCION DE
CANAL. Then press
ENTER.
Press MENU.
Press ▲ or ▼ to select the
SINTONIZAR CANAL.
Then press ENTER.
The Auto CH Memory function(See page 11) memorizes all broadcasts to the suitable CH positions by where
you done this function.
However one broadcast may not be memorized depend on the bad receiving condition. In case of these broad-
cast, use this Manual tuning function.
Manual station presetting
You activate the auto search function until your preferred station is tuned in. Then you memorize this station into the
chosen channel memory. For each station you repeat this procedure.
Example: Preset the SAT1 on program position 5.
6
If the picture is not satisfac-
tory press ▲ or ▼ until the
best picture is achieved.
Then press ENTER.
7
Repeat the steps 3 and 7 to preset other TV stations.
8
Press ▲ or ▼ repeatedly
until "5" displayed. Or enter
5 with 10 number buttons.
Then press ENTER.
9
Press MENU repeatedly until the TV picture appears
on the screen.
Note:
Occasionally, the auto search might catch a weak signal
and stop. If the TV station signal is weak, you shouldn't
store this station.
In that case restart the auto search using
or .
automatically (" " change
to " "). Press or re-
peatedly until the SAT1 ap-
pears. If you want to stop the
searching, press / or ▲ /
▼.
AJUSTE GRAB TEMPORIZADA
REPETIDOR AUTO [OFF]
SINTONIZAR TV
SELEC :
ENTRAR
: ENTER
: MENU
SALIR
SINTONIZAR SISTEMA
SINTONIZAR CANAL
AUTO TUNING
CAMBIO
SELEC :
ENTRAR
: ENTER
: MENU
SALIR
PRESELECCION DE CANAL
SINTONIZAR CANAL
CH 1
MENUSALIR :
SELEC :
OK : ENTER
DEC OFF
SECAM
CH 1
BUSQUEDA :
/ S. FINA :
MENU
SALIR
:
DEC OFF
SECAM
CH 1
DEC OFF
BUSQUEDA :
/ S. FINA :
SECAM
OK : ENTER
SALIR : MENU
CH 5
CH
:
ENTER
OK
:
MENU
SALIR :
/ 0–9
DEC OFF
SECAM
3
Press ▲ or ▼ to select the
“PAL” or “SECAM”. Then
press ENTER.
CH 1
MENUSALIR :
SELEC :
OK : ENTER
DEC OFF
SECAM
DEC ON/OFF selecting function is available only for
COMBI 2115 SI
DEC OFF will blink. Press
ENTER. DEC OFF does not
blink anymore. BUSQUEDA
will appear.
Note:
lf you wish to store the PRE-
MIERE manually, the decoder must have been
connected.
During DEC OFF is blinking, press ▲.
DEC ON will blink now.
press ENTER.
5H00701A P11-18 12/11/03, 10:15 AM13
To Next Page
Loading...
Need help?
General
