7 PREPARING YOUR DEVICE
Remove the battery compartment cover.
Pull o the isolation strip to allow the
battery to make electrical contact.
Reinstall battery cover.
NOTE: Ensure the battery polarity (+/-)
matches the battery compartment sign.
On the
Add location
setup page,
you can edit
Home name
, set up
Home location
and
Select rooms
or
Add room
.
This will help you manage your
GRID devices and assist you in
customising and scheduling the
time and order of one or multiple
devices, depending on your home
living needs.
Tap Done when you finish.
8.0 PAIRING YOUR DEVICE
Open the GRID CONNECT App. Tap
, then select
security
on the
add
device
page. Confirm the status light
around the push button is flashing
red, one flash per second before
tapping ‘ready to pair’ to proceed.
If the status light is not flashing
red, press the push button once
to activate the video doorbell then
press and hold the reset button
from the bottom of the video
doorbell for 5 seconds until a
prompt is heard. After 10 seconds,
the status light will start flashing red.
Tap ‘ready to pair’ to proceed.
76
24 pages 105mm x 148mm (A6) 160gsm Gloss Art Stock 4 colour process double sidedDC55HA Series 2 - CPIN005156/4