10 PAIRING INDOOR CHIME UNIT
Power on your indoor chime unit with
either a standard USB-A port or
provided DC power adaptor, ideally
some where near your door.
Your indoor chime unit should have
been paired with your video doorbell.
Please press the push button on the
video doorbell to test the indoor
chime. If the indoor chime does not
react, please follow step 1-3:
1. Press the reset button on the back
of the chime unit for 5 seconds to
reset the chime unit. The indicator
should flash blue quickly for 2
seconds then stop flashing, proceed
to step 2.
2. Press the reset button on the back of
the chime unit ONCE and release it
quickly. The indicator should flash blue
slowly and continuously.
3. While the chime unit is continues
flashing, you may chose one of the
following options to finish pairing:
a. Press the video doorbell’s push
button once to complete indoor
chime unit setup.
OR
b. Navigate from the video doorbell live
screen settings -> bell settings ->add to
complete indoor chime unit setup.
USB-A Port
DC Power Adaptor
1514
24 pages 105mm x 148mm (A6) 160gsm Gloss Art Stock 4 colour process double sidedDC55HA Series 2 - CPIN005156/4
To Next Page
Loading...
Need help?
General
