11
HANDLEBAR INSTALLATION
STEERING STEM
1. Loosen the M4 SCREWS that secure the lower handlebar clamp onto the steering stem.
2. Rotate the lower clamp approximately 180 degrees, ensuring it faces forward and is
evenly balanced between the fork.
3. Securely tighten the M4 SCREWS.
4. Remove the center plastic piece covering the M5 SCREW in the center of the steering stem.
5. Tighten the M5 SCREW securely, reinstall plastic cap.
6. Once the bike is fully assembled, check to ensure that the handlebars and front wheel are
even. Verify that there is zero play in the handlebars, front wheel, fork, and steering stem.
To Next Page
Loading...