16
ADJUST BRAKE
To adjust the brake cable, follow these steps:
1. Twist the brake lever adjuster in or out, making 1⁄4 to 1⁄2 turn adjustments at a time until
the desired brake adjustment is achieved. If the brake still requires further adjustment,
proceed to step 2.
2. Determine whether the brake cable is loose or if the brake rotor is dragging on the brake
pad: Loosen the brake hub’s barrel adjuster.
3. Adjust the brake hub adjuster in or out until the desired brake adjustment is achieved.
Lock the brake hub barrel adjuster in place.
4. Perform a nal adjustment of the tension in the brake cable using the brake lever barrel
adjuster. Repeat the TEST BRAKE section above to ensure proper adjustment.
PRE-RIDE CHECK LIST
5. WHEELS
• Check the condition of both tires and ensure the tread is in good condition, and free
from punctures, cracks, and deformations.
• Maintain proper tire pressure. Orion Moto recommends a range of 25-35 PSI
dependent on the weight of the rider and the type of terrain.
• Ensure the wheels are aligned correctly and true.
• Ensure the wheels are properly seated in the dropouts and that the wheel nuts are
tightly secured.
6. BATTERY
• Familiarize yourself with battery charging and storage for best practices.
7. BRAKE SYSTEM
• Pull the Brake Lever; You should sense a distinct pressure point, and the levers
should remain unable to make contact with the handle.
8. CABLES
• Look for any loose cables.
• There should be no strain on any wiring near the fork when turning the handlebars
from left to right.
9. KICKSTAND
• Make sure that the kickstand is tightly secured and not rubbing against the ground
or tires.
BEFORE YOU RIDE
To Next Page
Loading...