15
2. Put the washer on the long M5 screw, insert it into the headlight mounting bracket and
push it through the hole in the fork above the front tire.
3. Put the 10mm nut on the screw at the back of the fork and tighten.
4. Adjust headlight angle by slightly pushing forward and down or backwards and down until
it is in its desired location.
5. Make sure the light is working
BRAKE LIGHT INSTALLATION
1. Connect the tail light quick connect found near the rear of the bike on the right side near
the motor.
2. Align the M4 SCREWS and washers with the holes on the rear right side of the frame.
3. Tighten the screws down to secure the brake light.
4. Zip tie the brake light cable so that it is secure to the frame and out of the way of the rear wheel.
TEST BRAKES
1. Squeeze the brake lever and hold it.
2. Attempt to push the bike forward.
3. If the brake is adjusted correctly, the rear wheel should not spin.
4. Check brake light to ensure that it is working properly.
To Next Page
Loading...