12
HANDLEBARS
1. Use the 4MM HEX WRENCH provided to remove the bolts from the handlebar clamp.
2. Once the clamp is open, place the lower crossbar of the handlebar in the groove of the
top crown.
3. Loosely tighten the handlebar clamp with 4mm hex wrench and adjust the handlebar to a
90 degree angle aligning with the forks.
4. Cross-tighten the handlebar clamp from corner to corner making sure the bolts are tight
and handlebar does not move.
5. There are 4 screws to assemble or disassemble the handlebar. Be sure to rotate the
handlebar so the on/o switch is easy to reach.
FOOT PEG INSTALLATION
PLASTIC FOOT PEG INSTALLATION:
1. The plastic foot pegs are versatile and can be used on either side of the bike.
2. Hold the foot peg in the correct position so that the mounting hole on the foot peg is
aligned with the threaded hole on the frame.
3. Insert the provided M6/1.25X25MM screw into the mounting hole. Utilize the provided
6MM ALLEN WRENCH to initiate tightening the screw. Ensure that the screw is threading
smoothly and avoid tightening if it feels cross-threaded.
4. Complete the tightening process and verify that the foot peg is correctly aligned.
5. Periodically check the tightness of the screws holding the foot pegs on.
To Next Page
Loading...