13
INSTRUCTIONS FOR ASSEMBLING FOLDABLE METAL FOOT PEGS:
CAUTION: USE APPROVED SAFETY GLASSES
The folding metal foot pegs are side specic. The mounting position for the return spring is in
the down position for each foot peg. See picture.
1. Gather the provided M6 SCREW, mounting bracket, grooved washer, and spacer, and
assemble them in the following order.
2. Hand-thread the M6 SCREW into the threaded hole on the side of the bike. Ensure
smooth threading and avoid tightening if it feels cross-threaded. Use the provided M6
Allen wrench to tighten the screw.
3. Before fully tightening the screw, ensure that the bracket is correctly aligned, as depicted
in the accompanying picture.
4. Complete the tightening process.
5. Take the provided spring and position it on the foot peg, ensuring the larger part of the
spring covers the inner part of the foot peg.
6. Press the smaller opening of the spring onto the back part of the mounting bracket and
push the foot peg into place.
To Next Page
Loading...