15
Basic Operation
Note:
If the built-in tuner does not receive
anything (e.g. if no antenna is
connected) during TV-operation, then
the TV-unit will change to standby
after approx. 15 minutes.
•
Channel selection
With the numbered buttons.
Example:
No. 2: Press 0 and within 2 seconds, press 2.
No. 29: Press 2 and within 2 seconds, press 9.
Press P + or – to change up or down a channel. This
takes approx. 2 seconds. If the auto search only
stored 5 stations, only these 5 will appear. Skipped
channels will not appear (see P.13).
•
•
CH LIST
The CH LIST shows a list of all receivable
programmes. They are located in channels 1 to 99.
Press CH LIST to display the CH LIST.
Press
or to select the desired channel.
Press CH LIST to display the selected channel.
Press EXIT to exit.
QuickView
button allows you to go back to the last selected channel.
Volume adjusting
Press
+ or – to adjust the volume. The volume level indicator
disappears after 4 seconds.
MUTE
Press
. The sound will be cut off. MUTE will appear for
approx. 4 seconds.
The muting can be released by pressing
again or + or –.
Information display
In the analogue TV mode:
Press
. Channel number
and picture size setting
will appear for approx. 4
seconds.
In the digital TV mode:
Press
. The program
information will appear (see
‘Channel banner’ on page
29).
SLEEP TIMER
To set the sleep timer press
. SLEEP and the minutes until
shut-off will appear. Each time you press
the SLEEP time
shown will change. When the displayed time runs out, the unit
will switch to standby. The display will disappear after approx. 4
seconds
To cancel the sleep timer:
Press
repeatedly until ‘0’ appears.
STEREO 1
ARD
AUTO
32G0146B_ENG.indd 1532G0146B_ENG.indd 15 10/11/07 1:52:20 PM10/11/07 1:52:20 PM
To Next Page
Loading...
