Orion TV19PL110D - Location of Controls; Control Panel Overview; Remote Sensor and Indicator Light

7
Location of controls
Description of Indicators and Controls
1. Remote sensor
2.
(Standby/Timer/On) indicator: The LED indicator lights up red in standby mode, orange in
standby mode when the timer is activated, and green in the power ON mode.
3. Loudspeakers
4.
(Volume) +/– buttons / In Menu: Setting.
5.
(Channel) ▲/▼ buttons: Press ▲ to change to a higher numbered channel set into memory. Press
▼ to change to a lower numbered channel set into memory. In Menu: Setting. In Standby: Turning on
the unit.
6. MENU button: To display the menu screen.
7. TV/AV/PC button: Select input mode for TV/AV/COMPONENT/HDMI/PC. In Menu : Using as ENTER
button.
8.
(Power)-key: Preparation: Connect power-cable to 230V/50Hz.
a) If standy-LED is red, you may power-off. To power-off, press power-key 1x and release.
For confirmation, standby-LED will change to dark.
b) If standby-LED is off, you may power-on. To power-on, press power-key 1x and release.
For confirmation, standby-LED will change to red and about 1 second later to green.
c) If the TV is currently working, press power-key 1x and release to power-off.
For confirmation, standby-LED will change to dark.
In power-off-condition, the TV’s power-consumption is approx. 1 Watt.
If total disconnection from the mains is required, pls unplug.
45678
3
12
Front Side
To p
32G0146B_ENG.indd 732G0146B_ENG.indd 7 10/11/07 1:52:12 PM10/11/07 1:52:12 PM