28
Version/Software Upgrade/ Common Interface
Version
You can check the software and hardware versions.
1
Press or
to select ‘Version’, then press ENTER.
The hardware and software versions are displayed.
Software upgrade
Version
Main menu Technical Information
AC
B
Software Upgrade
Software Upgrade allows you to download the latest software
available on the Engineering channel.
1
Press or
to select ‘Software upgrade’, then press
ENTER.
Software upgrade
Version
Main menu Technical Information
AC
B
2
If a software upgrade is available from an Over- Air-
Download (OAD) then the message ‘S/W available, do you
want to download?’ will be displayed - you can then select
‘Yes’ or ‘No’ by pressing
or , then press ENTER.
3
If you select the option ‘Yes’ then the Software Upgrade
process will be initiated. It will take about 20 minutes and
after this process is complete, the TV will be rebooted
automatically.
If you select the option ‘No’ you can continue to watch TV
programmes as before.
Note:
During the Software Updating
process, do not turn off the unit. At
this time you cannot use any of the
buttons, apart from
(STANDBY).
After the Software Updating process,
the Digital Menu memory settings
will be lost, so it is necessary to go
through the setting up procedures
again.
•
•
Common Interface
You can access the Common Interface module information from
this menu option.
Preparations
Insert CAM into the DVB Common Interface slot on the backside
of the TV (see page 10).
1
Press or to select Common Interface option, then
press ENTER.
ecafretnI nommoCu
n
em niaM
AC
B
2
The CAM module name will be displayed. You have to press
ENTER to view further information.
3
In the CI Menu, CAM specific information such as Module
information, Smart card information, Language and
Software Download are shown.
Press
or to select information, then press
ENTER to see detail.
4
Press EXIT to return to the normal screen.
32G0146B_ENG.indd 2832G0146B_ENG.indd 28 10/11/07 1:52:28 PM10/11/07 1:52:28 PM
To Next Page
Loading...
