14
1
Preparation: connect analog rf-cable-supply. Select
memory-cell 2. Press key 2 (see page 17). OSD will indicate
2
in right upper corner. Eventually recently stored TV-
channel’s name might also appear.
2
Press ANALOG MENU. Press
or
to select tool-page (see here).
Press
or to select MANUAL
TUNING.
Press ENTER.
AUTO TUNING
MANUAL TUNING
CH ALLOCATION
LANGUAGE
ENGLISH
AV1 OUTPUT TV
AV COLOUR
AUTO
3
COLOUR SYSTEM and SOUND
SYSTEM has already been preset
to AUTO.
Do not touch.
AUTO
SEARCH
FINE 168.30MHz
COLOUR SYSTEM
AUTO
AUTO
SOUND SYSTEM
VOX 168.30MHz
4
Press or to select SEARCH.
Press ENTER. Press
-key, to start
tuning. Tuning will stop automatically
at next available station. If this does
not happen to be the ZDF, press
-key again to continue tuning for the
ZDF. Tuning will work only in forward
direction.
Then press ENTER.
SEARCH
FINE 168.30MHz
COLOUR SYSTEM
AUTO
SOUND SYSTEM
AUTO
ZDF
175.30MHz
5
If you like use fine-tuning. Select
FINE and press ENTER. Press
or
, to fine tune. See the note on
this page.
ZDF 175.30MHz
SEARCH
FINE 175.30MHz
COLOUR SYSTEM
AUTO
AUTO
SOUND SYSTEM
6
To store other stations in additional memory-cells, repeat
steps 1 to 5.
7
Press EXIT to return to the normal screen.
Manual TV station presetting
If you like, you may manually tune a certain station into a selected memory-cell, without deleting
or modifying other memory-cell’s contents. Example: Store the ZDF into memory-cell 2.
Notes:
Usually fine tuning is not necessary,
due to tuning’s automatically
stopping at the very best position. If
you fine-tune anyway, proper working
of teletext-reception with built-in
tuner is no longer guaranteed.
Tuning does work only in direction
of higher frequencies (up). Tuning
towards lower frequencies (down)
is not supported. However, when
tuning has reached tuning-range’s
end (highest frequency), it will restart
automatically from the starting
position (lowest frequency).
•
•
32W0146A_ENG.indd 1432W0146A_ENG.indd 14 6/6/07 10:54:00 AM6/6/07 10:54:00 AM
To Next Page
Loading...
