Orion TV20RN10D - Version and Software Upgrade

38
Version/Software Upgrade
Version
You can check the software and hardware versions.
1
Press DIGITAL MENU, the menu will appear on the screen.
Press
or to select Technical Information option. Press
or
to select ‘Version’ from sub menu tab, then press
ENTER.
Version information banner will appear.
Software upgrade
Version
Main menu Technical Information
A C
B
AC
B
2
This banner provides the below informations:
Hardware Version
Software Version
•
•
Version
Hardwa
re version
A.0
Software version
CB00C73131
Enter Exit
Software Upgrade
Software Upgrade allows you to download the latest software
available on the Engineering channel.
1
Press DIGITAL MENU, the menu will appear on the screen.
Press
or to select Technical Information option. Press
or
to select ‘Software upgrade’ from sub menu tab,
then press ENTER.
Software upgrade
Version
Main menu Technical Information
A C
B
AC
B
2
If a software upgrade is available from an Over- Air-
Download (OAD) then the message ‘S/W available, do you
want to download?’ will be displayed - you can then select
‘Yes’ or ‘No’ by pressing
or , then press ENTER (the
selected option is shown in blue).
Confirmation
S/W available, do you want to download?
Yes No
3
If you select the option ‘Yes’ then the Software Upgrade
process will be initiated. It will take about 20 minutes and
after this process is complete, the TV will be rebooted
automatically.
If you select the option ‘No’ you can continue to watch TV
programmes as before.
Notes:
During the Software Updating
process, do not turn off the unit. At
this time you cannot use any of the
buttons, apart from
(STANDBY).
After the Software Updating process,
the Digital Menu memory settings
will be lost, so it is necessary to go
through the setting up procedures
again.
•
•
32W0146A_ENG.indd 3832W0146A_ENG.indd 38 6/11/07 10:35:01 AM6/11/07 10:35:01 AM