47
Troubleshooting table/Specifications
Troubleshooting table
Please check the following list before requesting service.
Symptom Possible solution Page
No picture, no sound Switch on the set.
Check that the mains power outlet is properly connected.
Select appropriate input mode.
10
12, 44,45
No reception Have you tuned in the TV stations?
Press 1 on the remote control.
Connect the antenna.
Make sure the set is ON and not in Standby mode
10
10
The TV switches off with
missing antenna input
signal
This is normal.
15 minutes after the antenna signal has disappeared, the set
will change to standby mode.
17
In
menu, the
TUNING option cannot be
selected.
The unit is set to AV mode. Press 1 on the remote control. 13
Wrong Colours Colour and Brightness errors can occur when the viewing
angle / ambient air temperature (see technical specifications)
are exceeded.
While viewing a DVB
(digital) channel, there is
sound but no picture.
Some channel offers audio content only. It is normal.
Blocky image or image
stops intermittently.
Check all antenna connections.
Move the antenna away from areas of possible interference.
Try using an antenna booster.
10
Some digital channels
cannot be viewed.
Contact the service provider to subscribe.
“Database empty” message
appears on the screen.
Check all antenna connections and try auto tuning again. 29
The LCD panel is a very high technology product, giving you fine picture details. Occasionally, a few nonactive pixels
may appear on the screen as a fixed point of blue, green or red. Please note that this does not affect the performance
of your product.
•
System Analogue: PAL UK, IR, CCIR, FRENCH System, B/G, D/K, I/I, L
Digital: DVB-T (OFDM 2k/8k 16QAM/64QAM)
Video Colour System PAL/SECAM/NTSC 3.58/NTSC 4.43/PAL 60
Preset channels: Analogue channels (99) + Digital channels (Carrier 200/Service1000)
Frequency Range Analogue: IreE2~E4, X~Z+2, S1~S10, E5~E12, S11~S41, E21~E69
Digital: E5~E12, ItaE~G, F1~F6, Rus6~12, E21~E69
Power Supply AC 220-240V, 50/60Hz
Power Consumption: Operation:
approx. 73W at 230V, 50Hz
Stand by: approx. 1W at 230V, 50Hz
LCD 20.1” TYPE (51 cm visible)
TFT low-glass Active Matrix Colour LCD, 640 x 480 Pixel
Output Power approx. 1.5W (MAX) x 2
Surrounding temperature Operation: 5°C ~ 40°C/Storage: –20°C ~ 60°C
Operating Humidity Less than 80%RH
Dimensions 47.8(W) x 46.3(H) x 21.1(D) cm
Weight (w/o Accessories) approx. 8.4 kg
Accessories 2 batteries (AA/R6/UM-3)/Remote control unit/AC cord
Weight and dimensions are approximate. Because we continually strive to improve our products we may
change specifications and designs without prior notice.
Specifications
32W0346A_ENG.indd 4732W0346A_ENG.indd 47 5/28/07 9:40:34 AM5/28/07 9:40:34 AM
To Next Page
Loading...
