© 2008 Directed Electronics. All rights reserved. 4
+BAT1. - connect this terminal through a FUSE or CIRCUIT BREAKER
to the positive terminal of the vehicle battery or the positive ter-
minal of an isolated audio system battery.
WARNING: Always protect this power wire by installing a fuse or
circuit breaker of the appropriate size within 12 inches of the battery
terminal connection.
REM2. - this terminal turns on the amplifier when (+) 12 volt is
applied. Connect it to the remote turn on lead of the head unit
or signal source. If a (+) 12 volt remote turn lead is not available,
a Remote Power Adapter (P/N #ORRPA) can be used to supply a
remote turn on signal. DO NOT connect this terminal to constant
(+) 12 volt.
GND3. - power return connection. Connect this terminal directly
to the sheet metal chassis of the vehicle, using the shortest wire
necessary to make this connection. Always use wire of the same
gauge or larger than the (+) 12 volt power wire. The chassis con-
nection point should be scraped free of paint and dirt. Use only
quality crimped and/or soldered connectors at both ends of this
wire. DO NOT connect this terminal directly to the vehicle battery
ground terminal or any other factory ground points.
CEA SPECIFICATIONS
XTR5001
Power Output: 150 Watts RMS x 1 at 4 ohms and
< 1% THD+N
Signal to Noise Ratio: >70 dBA (reference 1 Watt
into 4 ohms)
Additional Power: 600 Watts RMS x 1 at 1 ohm
and < 1% THD+N
XTR10001
Power Output: 300 Watts RMS x 1 at 4 ohms and
< 1% THD+N
Signal to Noise Ratio: >70 dBA (reference 1 Watt
into 4 ohms)
Additional Power: 1200 Watts RMS x 1 at 1 ohm
and < 1% THD+N
XTR15001
Power Output: 400 Watts RMS x 1 at 4 ohms and
< 1% THD+N
Signal to Noise Ratio: >70 dBA (reference 1 Watt
into 4 ohms)
Additional Power: 1600 Watts RMS x 1 at 1 ohm
and < 1% THD+N
To Next Page
Loading...
Need help?
General
