17
Area part arming
Zones can be grouped together to make ‘Area Sets’. Area Sets are often used in multi tenanted
houses where there is a communal entrance and separate living spaces. Users can arm
individual or multiple area sets. To part arm selected areas, please proceed as follows:
1. Enter your code or present tag to select the user menu.
2. From the user menu, use the
U andD keys to scroll to ‘Area part arm 1’:
3. Use the L andRkeys to change the part arm mode (1, 2 or 3), then press E or
k to select, the ‘part arm areas’ menu is now displayed:
` Area will be part armed
a Area will remain unarmed
4. Use the
U andD keys to select the ‘Area’. Then use theL andR keys to toggle
the selected area on or off. Once you have selected the areas that you would like to part
arm, press
E or k to confirm.
5. The exit tone will start and the keypad will instruct you to exit the protected area:
6. The keypad will then indicate that the areas that are part armed:
Part arm settings will be pre-programmed by your installation company.
To Next Page
Loading...
