EasyManuals Logo

ORTEC DSPEC User Manual

ORTEC DSPEC
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
6. COMMANDS AND RESPONSES
23
%000038080<CR>
Device preset already exceeded and High Voltage not enabled. The
command was ignored.
%000054078<CR>
Device preset already exceeded, High Voltage not enabled and
amplifier was not pole-zeroed. The command was ignored.
Power-Up Alert: Power-up just occurred and the selftest results are:
%001000070<CR>
All power-up selftest passed.
%003000072<CR>
Battery backed-up data lost.
Command Syntax Errors:
%129001082<CR>
Invalid command verb.
%129002083<CR>
Invalid command noun.
%129003084<CR>
Invalid command verb and noun.
%129004085<CR>
Invalid command modifier.
%129005086<CR>
Invalid command verb and modifier.
%129006087<CR>
Invalid command noun and modifier.
%129007088<CR>
Invalid command verb, noun, and modifier.
%129132087<CR>
Invalid command (verb, noun, and modifier valid but not together).
Communication Errors:
%130001074<CR>
Serial line buffer overrun.
%130002075<CR>
Serial line parity error.
%130003076<CR>
Serial line buffer overrun and parity error.
%130004077<CR>
Serial line framing error.
%130005078<CR>
Serial line buffer overrun and framing error.
%130006079<CR>
Serial line parity error and framing error.
%130007080<CR>
Serial line buffer overrun, parity error, and framing error.
%130008081<CR>
Serial line break detected.
%130128084<CR>
Command checksum incorrect (only when optional checksum
provided).
%130129085<CR>
Command (or WRITE handshake) record too long.
%130131078<CR>
WRITE command aborted by HA handshake.
%130132079<CR>
WRITE command aborted by timeout.
%130133080<CR>
WRITE command aborted by invalid handshake.
Execution Errors:
%131128085<CR>
Invalid 1st command parameter.
%131129086<CR>
Invalid 2nd command parameter.
%131130078<CR>
Invalid 3rd command parameter.
%131132080<CR>
Invalid number of command parameters.
%131134082<CR>
Invalid device or segment selected.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ORTEC DSPEC and is the answer not in the manual?

ORTEC DSPEC Specifications

General IconGeneral
BrandORTEC
ModelDSPEC
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals