6. COMMANDS AND RESPONSES
47
$C00010088<CR>
Coarse gain reported as 10.
$C00020089<CR>
Coarse gain reported as 20.
$C00050090<CR>
Coarse gain reported as 50.
$C00100088<CR>
Coarse gain reported as 100.
SHOW_GAIN_CONVERSION
This command returns the conversion gain.
Responses:
$C00512095<CR>
Conversion gain reported as 512 channels.
$C01024094<CR>
Conversion gain reported as 1024 channels.
$C02048101<CR>
Conversion gain reported as 2048 channels.
$C04096106<CR>
Conversion gain reported as 4096 channels.
$C08192107<CR>
Conversion gain reported as 8192 channels.
$C16384109<CR>
Conversion gain reported as 16384 channels.
SHOW_GAIN_FINE
Returns the current fine gain setting. See SET_GAIN_FINE.
Sample Response:
GAIN_FINE 0000000000000.5
Parameter is set to 0.5.
SHOW_GAIN_PRESET
Reports the Gauss mode stabilization preset for the gain peak. The preset represents the
minimum number of incremental counts that must be collected in any one channel of the gain
peak before the gain is evaluated by the stabilizer and potentially adjusted. See also
SET_GAIN_PRESET and CLEAR_PRESETS.
Responses:
$G0000000010076<CR>
Gain preset currently 10 counts (minimum).
$G0000000011076<CR>
Gain preset currently 11 counts.
... ...
$G2147483647121<CR>
Gain preset currently 2147483647 counts (maximum).
SHOW_GAIN_STABILIZATION
Reports the state of gain peak stabilization. See also ENABLE_GAIN_STABILIZATION and
DISABLE_GAIN_STABILIZATION.
Responses:
$IT<CR>
Gain stabilization is currently enabled.
$IF<CR>
Gain stabilization is currently disabled.
SHOW_GAIN_WIDTH
Reports the current width for the stabilizer gain peak. See also SET_GAIN_WIDTH,
SET_GAIN_CHANNEL, and SHOW_GAIN_CHANNEL.
To Next Page
Loading...
