Osburn 1700-I Owner's Manual

Page 20
Product Specication Manual - Osburn 1700-I
ENGLISH
The two main causes of broken door glass are uneven placement in the door and over-
tightening the retaining screws.
4.1.6 Glass Gasket Replacement
The glass gasket is flat, adhesive-backed, woven fibreglass. The gasket must be centred on the
edge of the glass.
1. Follow the steps of the previous section to remove the glass.
2. Remove the old gasket and clean the glass thoroughly.
3. Peel back a section of the paper covering the adhesive and place
the gasket on a table with the adhesive side up.
4. Stick the end of the gasket to the middle of one edge, then press
the edge of the glass down onto the gasket, taking care that it is
perfectly centred on the gasket.
5. Peel off more of the backing and rotate the glass. The gasket must
not be stretched during installation.
6. Cut the gasket to the required length.
7. Pinch the gasket onto the glass in a U shape, all around the glass.
By following these instructions, the edge clearances are maintain.
4.2 Blower and Ash Lip Installation
1. Install the ash lip (A) on the insert with
three screws (B).
2. Center the blower on the ash lip and push
it against the firebox. Then push it until it
clips.
A
B

Osburn 1700-I Specifications

General

Brand	Osburn
Model	1700-I
Category	Indoor Fireplace
Language	English