Osburn 1700-I Owner's Manual

Page 5
Product Specication Manual - Osburn 1700-I
ENGLISH
2. General Information
2.1 Performances
Values are as measured per test method, except for the recommended heating area, firebox volume,
maximum burn time and maximum heat output.
Model Osburn 1700-I (OB01705)
Type of combustion
Non-catalytic
Fuel Type
Dry Cordwood
Recommended heating area (sq. ft.
.
)
1
500 to 1,800 ft
2
(46 to 167 m
2
)
Overall firebox volume
2
1.86 ft
3
(0.053 m
3
)
EPA loading volume
1.44 ft
3
(0.041 m
3
)
Maximum burn time
1
7 hours
Maximum heat output (dry cordwood)
3
65,000 BTU/h (19 kW)
Overall heat output rate (min. to max.)
2 4
11,500 BTU/h to 43,300 BTU/h
(3.37 kW to 12.69 kW)
Average overall efficiency
3
(Dry cordwood)
73 % (HHV)
5
78 % (LHV)
6
Optimum overall efficiency
7
85 %
Optimum heat transfer efficiency
8
77 %
Average particulate emissions rate
9
1.9 g/h (EPA / CSA B415.1-10)
10
Average CO
11
78.7 g/h
1
Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type
and other variables. The recommended heated area for a given appliance is dened by the manufacturer as its capacity to maintain a minimum
acceptable temperature in the designated area in case of a power failure.
2
The overall rebox calculation is an approximation and is not intended to be used for loading. This volume includes a buffer zone to allow an easier
fuel insertion, prevent ash spillage and allow the air wash to work properly.
3
The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft
3
and 20 lb/ft
3
. Other performances are based on
a fuel load prescribed by the standard. The specied loading density varies between 7 lb/ft³ and 12 lb/ft
3
. The moisture content is between 19%
and 25%.
4
As measured per CSA B415.1-10 stack loss method.
5
Higher Heating Value of the fuel.
6
Lower Heating Value of the fuel.
7
Optimum overall efciency at a specic burn rate (LHV).
8
The optimum heat transfer efciency is for the low burn rate and represents the appliance's ability to convert the energy contained in the wood logs
into energy transferred to the room in the form of heat and does not take into account the chemical losses during combustion.
9
This appliance is ofcially tested and certied by an independent agency.
10
Tested and certied in compliance with CFR 40 part 60, subpart AAA, section 60.534(a)(1(ii) and ASTM E3053-17. Based on EPA letter dated November
1, 2022.
11
Carbon monoxide.

Osburn 1700-I Specifications

General

Brand	Osburn
Model	1700-I
Category	Indoor Fireplace
Language	English