9. How to clean the probe
If the probe becomes clogged in the hole at the tip, clean it using the following procedure.
Probe head
To remove the ear tip, hold firmly but carefully on the probe head and then remove the old ear tip and replace it
with the new one.
If there is ear wax or other things in the probe head, then the probe can be dismounted for better cleaning.
Please do as shown in the next figures.
Probes handle Probe head
To remove the probe head, hold firmly but carefully on the probe handle and then gently pull the probe head off.
Be careful not to bend the small metal pipe. If anything is stuck inside the metal pipe
be careful not to push it further in when removing it.
The probe head can be cleaned in lukewarm water and soap.
To Next Page
Loading...
