iDSP INSTALL GUIDE
Get Response
Get Response function using a combination of the phone’s mic signal (corrected by model related LUT) to build frequency
response plot across the slow and accurate sweep within HPF to LPF range. The function builds a THD plot as well, as
an easy way to see if high distortion levels affect an accuracy. The last one is a frequency response plot that could be set
as Reference by double tap on that plot or tap & hold > 1S, slide up/down on the Compensate/Resp window to adjust a
smoothness.
Response & Compensation window.
Response & Compensation window after response.
iDSP manual rev1 simon.indd 11 12/7/20 8:28 AM
To Next Page
Loading...
