OSIM uJolly 2 - Operation; Powering On and Initial Use; Stopping Operation and Resetting Rollers; Operational Notes and Timers

8
9
To switch on the power
• The ‘Hi’ LED indicator at the ‘Shoulders
Position’ button [ ] will light up followed
by the ‘Stop’ button [ ] LED indicator.
• Only the ‘Stop’ button [ ] LED indicator
will blink for about 5 seconds.
• Once it stops blinking, it indicates that the
uJolly 2 is ready to use.
• The roller width adjustment is available
during ‘Rolling & Tapping’ [ ] massage.
• The spot massage which can
make adjustment to roller position
[ ] is available during ‘Press-Grip’ [ ]
massage.
Note
• The massage rollers will move to the
default position after 15 minutes of
use or if the power button is pressed
to switch off the uJolly 2. In case of
electrical disruption, the massage rollers
will move to the default position once
power is restored.
• The 15 minutes auto timer still applies
when switching between auto or manual
massage programs.
Operation
To return rollers to default position
• Press the ‘Stop’ button [ ] again
to return the rollers to its default
position. The ‘Standby’ LED indicator
will blink until the rollers stop moving
and has reached the default position.
The ‘Standby’ LED indicator and the
‘Shoulders Position’ LED indicator will
remain on.
To stop a program or stop all
operation
• Press the program button that is
illuminated on the controller at any time
to stop the specific program.
• Press the ‘Stop’ button [ ] at any time
to stop all operation.
• The massage rollers will stay on its
last position and all LED indicators will
turn off except for the ‘Standby’ LED
indicator and the ‘Shoulders Position’
LED indicator.