18
OTICON ACTO FITTING GUIDE
19
Use a finger nail to dislodge the ear grip and push from
the other side.
1. Insert the earpiece into the ear canal.
2. Place the hearing device behind the ear. The Receiver unit
with the correct earpiece should be placed far enough into
the canal so that the wire lies flush with the client’s head.
When looking at the client face to face you should not see
the Receiver wire sticking out.
3. If necessary add the ear grip for extra retention.
If the ear grip is too long in the concha it may be trimmed.
Use caution not to leave a pointy end as this may irritate
the ear.
Pull the ear grip until its top is positioned
in the slot. During insertion, the top should
point away from the dome as illustrated.
Removing the Ear Grip Inserting and placing the device on the ear
1 2 3
To Next Page
Loading...
