68
OTICON INTIGA FITTING GUIDE 69
Pairing
Prepare the mobile phones:
1. Refer to the manual of the mobile phone for detailed
instruction on how to conduct the pairing (normally, it is
referred to as “find new Bluetooth device”). Set up the
mobile phone as instructed.
Note: For further information refer to the pairing guide
located on www.oticon.com
Prepare Streamer:
2. Assure that the key lock is deactivated.
3. Press Streamer Connect button for 6 seconds until
the blue light starts flashing rapidly.
The two devices are now establishing a connection to each
other.
Mobile phone handling:
4. When the mobile phone has received Streamer
information, ‘Streamer x.y’ will appear in the display.
5. Go to ‘Streamer x.y’ in the mobile phone display and
press select.
6. You will now be prompted for a pincode: all Streamer
pincodes are four zeros (0 0 0 0) – note, that just like for
other pincodes the 0’s most probably will appear as
asterisks (*).
7. Streamer and the mobile phone are now paired.
The pairing is done only once. If the phone is switched off
or Streamer is out of battery, the units will remained paired
when turned on again.
Daily Use
Phone calls with Streamer
Streamer must be within 10 meters of the mobile phone.
The connection must be active in order for Streamer and
mobile phone to work:
Press and hold the Connect button for 2 seconds until the
blue light turns on. After one minute the blue light will
automatically go into sleep mode (slowly fading on/off
every 5 seconds) to prolong battery lifetime.
Streamer and mobile phones
Pressing the Volume button for 2 seconds again activates
the hearing instrument microphones.
Note: the microphone state is memorized for each stream-
ing application by Streamer. Next time your client is
watching TV/making a phone call, the memorized micro-
phone state will be used.
The memorized microphone states are reset when the
“Connect” function is turned off.
To Next Page
Loading...
