WARNING
Incorrect pushing or pulling of the wheelchair
Falling, tipping over due to user error
► Only the push handles may be used for pushing or overcoming obstacles.
► The attendant should make sure that he/she has a secure stance and firm grip (on both sides).
► In case of damage, have the push handles repaired promptly.
CAUTION
Use of the product during diagnostic examinations and therapeutic treatment
Impairment of the examination results or the effectiveness of treatment due to interactions of the product with
devices that are used
► Make sure that examinations and treatments are carried out exclusively under the prescribed conditions.
CAUTION
Uncontrolled driving behaviour, unexpected sounds or odours
Falling, tipping, collision with persons or nearby objects due to defects
► If any faults, defects or other hazards that can lead to personal injury are detected, the product must be taken
out of service immediately. This includes uncontrolled movements as well as sounds that are unexpected or
previously not noted or odours that deviate significantly from the state of the product at the time of delivery.
► Please contact your authorised dealer.
NOTICE
Use under incorrect environmental conditions
Damage to product due to corrosion or abrasion
► Do not use the product in salt water.
► Make sure that the wheel bearings are not damaged by sand or other particles.
4.3 Side effects
The following side effects may occur during use of the product:
• Neck, muscle and joint pain
• Circulatory disorders, risk of pressure sores
Contact a doctor or therapist in case of problems.
4.4 Further information
INFORMATION
Even in the event of compliance with all applicable guidelines and standards, alarm systems (e.g. in department
stores) may respond to your product. Should this happen, remove your product from the area where the alarm
was triggered.
4.5 Nameplate and warning labels
4.5.1 Nameplate
The nameplates are found on the crossbrace.
Label Meaning
A Manufacturer’s product name
B CE marking
C Maximum load (see section “Technical data”)
D Manufacturer information/address
E Serial number
1)
F Manufacturing date
2)
G Manufacturer’s article number for the product variant
H WARNING! Read the instructions for use before using the
product. Observe important safety-related information
(e.g.warnings, precautions).
12
Safety
Start M2S, Start M2
To Next Page
Loading...
Need help?
General
