Otto Bock Start M2S - Page 14

CAUTION
Failure to verify readiness for use before putting into operation
Tipping, falling due to incorrect adjustment or installation
► Before you start using the wheelchair for the first time, check the chosen wheelchair settings with the support
of qualified personnel.
► After every assembly, check for proper mounting of the drive wheels. The quick-release axles must be
securely locked in the receiver bushings.
► Pay particular attention to the stability against tipping, free running of the drive wheels and correct function of
the wheel locks.
► Check the tyre pressure. The correct tyre pressure is printed on the sidewall. Ensure that the pressure is the
same in both tyres.
INFORMATION
On the topic of disassembly/transport: see Page35.
It only takes a few simple steps to prepare the wheelchair for use:
1) Attach the drive wheels to the receiver bushings (see fig.3):
→ Press in the button on the quick-release axle.
→ Attach the drive wheel to the receiver bushing and release the button on the quick-release axle.
→ The quick-release axles must not be removable after releasing the push-button.
2) Unfold the wheelchair (see fig.4).
3) Attach the leg supports (see Page15).
4) If necessary: Fold up the back support (see Page19).
5) If necessary: Pull the part of the flap that can be fastened forwards and fasten tightly to the seat upholstery
(see fig.5).
6) If necessary: Fit the seat cushion. The seat cushion is secured against sliding by being pressed on to the
hook-and-loop fastener (see Page19).
3 4
5
14
Preparation for use
Start M2S, Start M2