15
15. QUIET button
When QUIET function is on, the unit operates at very low speed to lower the sound level at its minimum.
You can also chose the AUTO QUIET function.
Under this function, in HEAT mode, the device will either run at medium or low (QUIET) speed according
to the difference between ambient and set temperature.
In COOL mode, the device will either run at low-medium speed or low (QUIET) speed according to the
difference between ambient and set temperature.
When you press this button, icon "
" (QUIET) appears on the screen. Press the button again to see the
icon (AUTO QUIET) and another time to cancel QUIET function.
16. SLEEP button
SLEEP function is available in COOL (cooling), DRY (dehumidifier) and HEAT (heating) modes only. This
function permits to gradually increase or decrease room temperature, so you can save energy without
affecting your sleep. This function is settled over an 8-hour period. After this period of time, the device
will work on previous established parameters, as it was set before SLEEP function was activated.
NOTE:
• Under DRY mode, only Sleep 1 can be selected.
• Press this button to select one of the three SLEEP settings: Sleep 1 (
), Sleep 2 ( ) or Sleep 3 ( ).
The corresponding icon will appear on the remote control.
• Sleep 1:
In COOL or DRY mode:
One hour after activation, the temperature setting will increase of 1 °C (1 °F or 2 °F). After 2 hours,
it will increase of 2 °C (3 °F or 4 °F).
In HEAT mode:
One hour after activation, the temperature setting will decrease of 1 °C (1 °F or 2 °F). After 2 hours,
it will decrease of 2 °C (3 °F or 4 °F).
• Sleep 2:
In this mode, the appliance will run according to a group of preset sleep temperature curves.
COOL mode:
Initial temperature setting between 16 °C to 23 °C (61 °F to 74 °F):
Temperature setting will be increased of 1 °C (1 °F or 2 °F) every hour up to 3 °C (5 °F or 6 °F). One hour
before the end of the SLEEP mode (after 7 hours), the temperature setting will be decreases of 1 °C (1
°F or 2 °F).
Initial temperature setting between 24 °C to 27 °C (75 °F to 81 °F):
Temperature setting will be increased of 1 °C (1 °F or 2 °F) every hour up to 2 °C (3 °F or 4 °F). One hour
before the end of the SLEEP mode (after 7 hours), the temperature setting will be decreases of 1 °C (1
°F or 2 °F).
Initial temperature setting between 28 °C to 29 °C (82 °F to 85 °F):
After one hour, temperature setting will be increased of 1 °C (1 °F or 2 °F) and will be maintained for
6 hours. One hour before the end of the SLEEP mode (after 7 hours), the temperature setting will be
decreases of 1 °C (1 °F or 2 °F).
Initial temperature setting 30 °C (86 °F) or above:
The unit will keep the initial setting. No temperature setting increase.
HEAT mode:
Initial temperature setting 16 °C (61 °F) or below:
The unit will keep the initial setting. No temperature setting decrease.
Initial temperature setting between 17 °C to 20 °C (62 °F to 68 °F):
After one hour, temperature setting will be decreased of 1 °C (1 °F or 2 °F) and will be maintained for
the duration of the SLEEP mode.
To Next Page
Loading...
Need help?
General
