www.cyrusher.com
11 / 29
Figure is 4.5~7.5km/h), showing the symbol of WALK. Release the button (or long
press the button for 3 seconds or shortly press the button ), the
ebike would exit WALK mode. There are two ways of exiting WALK mode, Long press and shortly
press. The specific using method will be according to the customer’s request. As the Image 13
shows.
6. System Parameter Settings
In the boot state, long press the button and , the system
enters parameter setting state(image 14). Under this state, setting the
cyclocomputer,
then long press the button and again to exit
the setting state or
No Operation(10s) and to exit setting state automatically. In
the parameter setting state, shortly press the button / to
adjust the figure of parameter setting, press the button to switch setting
item and save the parameter figure of the last item.
To Next Page
Loading...
