SelectingaPowerSupplyCord/Cordset
If purchasing a power supply locally, it should be supplied with an appropriate power supply cord or
cordsetforusewiththepowersupply. Ifit’snecessarytoselectapowersupplycordsetfortheOuster
supplied power supply, it should be safetycertified by a test house acceptable to the local region of
use, supplied with an IEC 60320, Type C6 cord connector to mate with the power supply and a plug
forconnectiontoanACoutletwithan earthingcontact/pin.
Environmental Ratings
AllInterfaceBoxesaresuitableforuseindoorsonlyinclean,protectedenvironmentsattemperatures
between -20 °C and +50 °C. Interface Boxes are not designed for use outdoors or in environments
thatarenot protectedfromdust,moisture,or highhumidity.
Mounting
The interface box may be mounted on a table top or on a wall (or similar vertical surface) not higher
than 2 m above the floor. Use not less than two (2) screws (M4 SHCS 10mm or longer are recom-
mended)tosecuretheinterfaceboxtothemountingsurface.
Figure7.7: MountingGuidelines -Ibox
ForadditionalOS2sensorCAD filesrefertoLidarProductDetailspage.
22
To Next Page
Loading...
