Outback Power Systems FLEXnet DC - Battery and Shunt Setup

24
Shunt 1 is, by default, enabled or active when the FX is
powered up. Pressing the <DIS> soft key disables the rst
shunt. Pressing the <DOWN> soft key leads to the shunt 2
mode and shunt 3 mode screens. These shunts are disabled
at power-up and are enabled by pressing the <EN> soft key.
When the setup for all shunts has been completed, press the
<DOWN> soft key for the next screen.
ADV/DC/SHUNT 1 ---------------
shunt 1 mode
DOWN EN DIS TOP
Press the <BAT> soft key.
ADV/DC/PAGE 1----------------
choose category
ADV BAT SHUNT PG2
ADV/DC/SHUNT-----------------
shunt setup complete
TOP ADV MAIN
Use the battery capacity screen to set the battery bank
capacity using either the <INC> or <DEC> soft key. When
nished, press the <TOP> soft key.
ADV/DC/BAT-------------------
battery capacity
amp hours
TOP INC DEC ADV
Press the <SHUNT> soft key.
ADV/DC/PAGE 1----------------
choose category
ADV BAT SHUNT PG2
Pressing the <DOWN> soft key
changes the shunt being enabled
or disabled.
Press the <ADV> soft key.
Press the <DC> soft key.
ADV--------------------------------
choose device:
FX CC DC MATE
Press the <PG2> soft key.
ADV/DC/PAGE 1----------------
choose category
ADV BAT SHUNT PG2