Outback EX200T - Page 17

17
Place the Side Burner Electrode (C9)
onto the side burner shelf as shown.
Place the Side Burner (C8) through the
central hole. Fit the side burner venturi
tube over the gas valve outlet. This is a
loose fit and not a gas tight seal. Secure
the electrode and burner with M4x10
Bolt (D3).
22
21
 Excel 200  Excel 300
 Excel 200  Excel 300
Place the Side Burner Grid (C6) onto the
side burner shelf.
NOTE: Make sure the base of cooking
utensil to put on the side burner is larger
than 150mm and smaller than 220mm.
Connect the electrode wire to the Ignition
Button (B8) under the control panel.
B8
D3
C9
C8
Main burner electrode
wire goes here.
Side burner electrode
wire goes here.
C6