oventrop Hydrocontrol MTR - Basic Information; 5 Installation & Initial Operation

"Hydrocontrol MTR" (lead-free) Installation & Initial Operation
13
5. Installation
& Initial Operation
5.1 Basic Information
Do not use the valve
indrinkingwaterlines.
Thevalvecanbeinstalledinany
orientation in either the supply
orreturnpipe.
WARNING
Risk of injury from
hot / cold surfaces!
Thereisariskofburns
from coming into contact
withthesystem.
  Beforeallwork,allow
the system section to
cool down until
surfacescanbetouched
withoutriskofinjury.
CAUTION
Risk of cuts from
sharp edges!
Threads,bores,andpipe
edgesmaycausecuts.
  Wearsafetygloves.
WARNING
Dangerfromttings
under pressure!
Workingon an operating
HVAC system is danger-
ous.Liquidwhenunder
pressurecanbeveryhot,
and its uncontrolled release
canresultinsevereinjuries.
  Performallworkona
depressurizedand
cooled-offsystemonly.
  Shut down the system
sectionandallowliquid
to drain in a controlled
fashion.
  Wearsafetyglasses
andgloves.