OverBuilt 10 - Important Safety Precautions

2
IMPORTANT
EYE AND EAR PROTECTION
Safety Devices
Valves are enclosed in a lockable cabinet.
This allows you to secure the valves from
unauthorized or unintentional use.
Safety lock can be placed on both ends of
the crusher. They are located on the uprights
and must be manually placed under the slides.
To lock the lid in the upright
position.
 Make sure the top lid is all of the way up.
 Remove the yellow safety lock located on
the uprights.
 Place the lock under the lid slides.
 Repeat on the other end.
The top lid is now blocked from falling.
NOTE: This safety lock is to prevent the top
lid from falling under its own weight. It may
not stop the lid from falling if you apply
downward hydraulic pressure to the cylinders.
Putting downward hydraulic pressure
on the lid with one or both of the safety
lock mechanisms in place may damage
the mechanisms or a cylinder rod.
Remove keys and do not run engine
when the safety locks are in place.
Always inspect the safety locks to
make sure they have not been damaged.
LOCKOUT PRECEDURE
Crusher lid may fall and death or serious
injury will occur if the following precautions
are not observed before getting on or into
the crusher:
1. Raise lid to full height.
2. Shut off crusher engine and remove
key.
3. Lock cabinet containing hydraulic
valves and remove key.
4. Carry all sets of keys with you.
5. Remove the yellow safety lock located
on the uprights.
6. Place the safety lock under the lid
slider.
7. Repeat on the other end.
8. When finished, remove safety locks
before lowering the lid.
Important: Never leave the crusher lid in a
raised position while the crusher is
unattended.
CRUSHER LOCATION
Lid rises higher than the frame of the
machine. Operating this equipment near
or below power lines may cause serious
injury or death.
Machine should be positioned on level
hard ground.
Never move crusher unless the crushing
chamber is completely empty and the
crusher lid is in the closed position.
Safety glasses and ear protectio
n
should be used at all times when
operating or standing near the
crusher.