To Next PageTo Next PageHow to fix Overhead door INFINITY 2000 beam not aligned?
If the Overhead door Garage Door Opener beam is not aligned, it could be due to an obstruction or a defective sensor. Check the source and sensor alignment and look for any obstructions that may be interfering with the beam.
Why is my Overhead door INFINITY 2000 not powered?
If your Overhead door Garage Door Opener is not powered, the wiring from the opener may be bad. Check the breakers, fuses, and plugs. Also, check the wiring for any shorts.
General| Brand | Overhead door |
|---|---|
| Model | INFINITY 2000 |
| Category | Garage Door Opener |
| Language | English |
Infrared beam across door opening. Stops/reverses door during down travel.
Force control reverses closing door upon contact with obstruction.
Explains hazards associated with garage doors and openers.
Defines safety alert symbols (DANGER, WARNING, CAUTION) and NOTE.
Lists hazards for moving doors, electrical shock, and high spring tension.
Reduce risk of severe injury or death; follow all instructions.
Opener has grounded plug; never use extension cord. Ensure proper grounding.
Lists compatible door types, sizes, and torsion bar requirements.
Operating door with frayed/broken cables can cause injury/death.
Do not loosen/remove bottom corner brackets; danger of injury/death.
Safety warnings for setting down limit.
Detailed steps for programming the down travel limit.
Detailed steps for programming the up travel limit.
Procedure to test the contact reverse function.
Safety warnings related to OHD Anywhere system and unattended operation.
Warnings against using force settings to compensate for door issues.
Chart for diagnosing Safe-T-Beam issues based on LED indicators.
General safety instructions for maintenance procedures.
Troubleshooting steps for unresponsive wall controls.
Troubleshooting steps when opener runs but door doesn't move.
Troubleshooting steps for remote control issues.
Troubleshooting steps for short-range or no remote operation.
Troubleshooting steps for door stopping/reversing or STB issues.
Troubleshooting steps for partial closing or only opening.
Chart correlating powerhead LED status to possible problems and solutions.
Troubleshooting steps for stopping during upward travel.
Chart for LED signals when using battery backup.
Troubleshooting steps for opener only closing the door.
Troubleshooting steps for unexpected opener activation.
Warning against walking under a moving door.
Warning about children playing with controls.
Warning about wall control placement for child safety.
Warning that garage door openers are not toys.
Warning to keep the moving door in sight until it stops.
Warning to keep children's hands away from door parts.
