34
Opener does NOT operate when wall control is pressed.
• Replace Wireless Wall Console Batteries, see page 33.
• If applicable, turn Sure-Lock™ OFF with Basic Wall Console, see page 14.
• Check power source
• If power is OK, check connections at powerhead terminals.
• Check for reversed, broken or cut wires. Staples can cut insulation and short wires. Repair or replace.
Opener runs, but door does not move.
• Ensure coupler set screws have not loosened, see page 9.
Opener works from wall control, but NOT from remote.
• Check all remotes.
• Replace remote battery, see page 33.
• Program remotes to powerhead, see page 21.
Remote has less than 25 feet operating range or no operation.
• Relocate remote inside car and /or point remote at garage door.
• Replace remote battery, see page 33.
• Eliminate possible competing signals (radio, etc.).
Door starts down, then STOPS and goes back up. OR Safe-T-Beam® System malfunction.
• If NEW Installation, make sure ONLY the Safe-T-Beams® that came with this opener are installed.
• Check if limits are properly set, see pages 18-19. Adjust limits as needed.
• Check if Safe-T- Beam® red LED is ashing. See page 29, Safe-T-Beam® system check.
• Check Safe-T-Beam® system for beam obstruction or misalignment of lenses. See page 29, Safe-T-Beam®
system.
• Check garage door for binding.
• Disconnect operator and try to manually close the door.
• If an operational problem exists, and opener will not close, the opener can be forced to close as follows:
Press and hold the wall control button until door is completely closed.
• Check for interference from adjacent Safe-T-Beam® unit, see page 29.
• Check opener Door Lock and wire connections, see page 11.
• Contact Overhead Door Corporation at 1-800-929-3667.
TROUBLESHOOTING
8
STOP
Need help or have questions? Call Overhead Door Corporation at
1-800-929-3667 or visit: www.overheaddoor.com
To Next Page
Loading...
