Overhead door INFINITY 2000 - Programming Additional Accessories; Wireless Wall Console Programming; Light Fixture Plug Safety

31
1. Press and hold the SET/PRGM button on the opener for 2-5 seconds.
• The ROUND LED will turn BLUE. Release button.
• The LONG LED will then ash PURPLE.
2. Press wall console main button 3 times slowly. Door should run.
The original wireless wall console and light kits are pre-programmed from the factory. However, if adding an
additional WIRELESS WALL CONSOLE or LIGHT FIXTURE to this unit or either original require reprogramming
for any reason, follow the instructions below.
• WIRELESS WALL CONSOLE
WARNING
IMPORTANT SAFETY INSTRUCTIONS
•This portable luminaire has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric
shock. This plug will t in a polarized outlet only one way.
•If the plug does not t fully in the outlet, reverse the plug. If it still does not t, contact a qualied electrician.
•Never use with an extension cord unless plug can be fully inserted.
•Do not alter the plug.
!
INSTALLING ADDITIONAL LIGHT KITS: (UP TO 3 LIGHT KITS TOTAL)
1. Press and hold the SET/PRGM button on the opener for 2-5 seconds.
• The ROUND LED will turn BLUE. Release button.
• The LONG LED will then ash PURPLE.
2. Press button on the LIGHT FIXTURE 1 time.
3. LIGHT FIXTURE will ash and beep.
4. LIGHT FIXTURE is now paired to opener and will operate as normal.
LIGHT FIXTURE INCLUDED WITH OPENER:
1. Power up Wall Mount Opener.
2. Power LIGHT FIXTURE.
3. LIGHT FIXTURE will ash and beep.
4. LIGHT FIXTURE is now paired to opener and will operate as normal.
Programming Additional Accessories