Ovesco remOVE DC Impulse - Disposal; Operating Conditions; Specifications

English; Version 08 | 2019-04-24
remOVE DC Impulse 400.01
Instructions for use
23 / 32
17 Disposal
When disposing or recycling the product or its components, please make sure to
follow national rules and regulations.
18 Operating conditions
When using the remOVE DC Impulse, please make sure the following operating
conditions are met:
Environmental factors
Value
Temperature
+10 °C to +40 °C
Relative humidity
25 % to 75 % RH non-con-
densing
Air pressure
700 to 1060 hPa
Operation level
≤ 4000 m
If the remOVE DC Impulse has been stored or transported at a temperature of less
than + 10 °C, it must be acclimated to room temperature for at least 3 hours.
19 Specifications
Isolation / Classification
EMC
IEC 60601-1-2:2014
Type of protection, through casing
IP 21
Type of protection, through foot-activated switch
IPX8
Type of protection according to EN 60601-1
II with functional earth
Type of applied part according to 60601-1
BF
Compliance with standards
IEC 60601-1: 2005+Cor.: 2006 +Cor.:
2007 + A1 2012
IEC 60601-1-2: 2014
IEC 60601-1-6:2010
ISO 14971: 2007
ISO 13485: 2003 + AC 2009
Classification according to 93/42/EEC
IIb
Symbol
Description
Products with this symbol have to be delivered to a separate col-
lection for electrical and electronic equipment. Inside the Euro-
pean Union, the manufacturer will dispose of the product free of
charge.