OWC Mercury Rack Pro - Converting to Desktop Unit

2.4 Converting to Desktop Unit
The OWC Mercury Rack Pro can be converted from a rack mounting enclosure to a
desktop unit by removing the rack pulls from the sides of the enclosure, and attaching
the included rubber feet to the enclosure.
To remove the rack pulls, simply remove the 4 Phillips screws on the side of the rack
and the rack pull will come o.
Once you have removed the rack pulls, turn the OWC Mercury Rack Pro over and at-
tach the 4 rubber feet using a Phillips screwdriver to the bottom of the enclosure.
OWC Mercury Rack Pro Chapter 2 - System Setup