EasyManuals Logo
Home>OWC>Storage>Mercury Rack Pro

OWC Mercury Rack Pro User Manual

OWC Mercury Rack Pro
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
OWC Mercury Rack Pro Chapter 1 - Introduction
RAID 1 “Drive Mirroring Mode (2 drives installed only)
Switch setting: UP-UP-DOWN
The drives show up as one volume, but only 50% of the total capacity can be used. It is
highly recommended to use identical drives for this RAID method. However, while you
can utilize drives of dierent capacity, the RAID size will be based on the smallest ca-
pacity total of the drives used in the RAID set. RAID 1 creates an exact copy (or mirror”)
of a set of data on the second drive. This is useful when reliability and backup are more
important than capacity. When one drive fails, it can be replaced and the data rebuilt.
RAID 10 “Drive Mirroring with Striping Mode
Switch setting: UP-UP-DOWN
The drives show up as one volume, but only 50% of the total capacity can be used,
depending on the drive with the smallest capacity. RAID 10 creates an exact copy (or
“mirror”) of a set of data but also uses a RAID 0 Stripe for speed. When one drive fails, it
can be replaced and the data rebuilt automatically.
RAID 3 “Drive Striping with Dedicated Parity” Mode
Switch setting: UP-DOWN-DOWN
The drives show up as one volume, but the total capacity, depending on the drive with
the smallest capacity, is the combined size minus the size of one drive. RAID 3 uses
byte level striping with parity data located on 1 drive. Very fast performance can be
achieved with RAID 3 while also maintaining fault protection, so if one drive fails, it can
be replaced and the data rebuilt automatically.
RAID 5 “Drive Striping with Distributed Parity Mode
Switch setting: DOWN-UP-DOWN
The drives show up as one volume, but the total capacity, depending on the drive with
the smallest capacity, is the combined size minus the size of one drive. RAID 5 uses
block level striping with parity data distributed across all member disks and therefore
provides the perfect balance between high performance and data integrity. When one
drive fails, it can be replaced and the data rebuilt automatically.
Storage Capacity
Data Safety
Performance
Storage Capacity
Data Safety
Performance
Storage Capacity
Data Safety
Performance
Storage Capacity
Data Safety
Performance

Other manuals for OWC Mercury Rack Pro

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the OWC Mercury Rack Pro and is the answer not in the manual?

OWC Mercury Rack Pro Specifications

General IconGeneral
BrandOWC
ModelMercury Rack Pro
CategoryStorage
LanguageEnglish

Related product manuals